Bass Flow

Bass Flow Bass Flow is a channel strip plugin designed for mixing bass. It contains 4 routable processing elements and a master section with input, output, and routing controls. The elements included are: Bass Character – A unique 2-band EQ that tracks the pitch of bass notes and allows for boosting or cutting the harmonics within the spectrum of the instrument. Spectral Bass Compressor – A spectral compressor with 6 control bands that are perfectly suited to help with electric bass problems like fret buzz, amp/room resonances, and lack of clarity. Equalizer – An intuitive 5-band EQ with 2 additional filter bands and a wide variety of band shapes. Chorus – A creative effect that can be used to boost presence or to add motion to a bass signal. Module Controls The processing elements are separated into modules which can each be individually bypassed, soloed, and reset using the following controls on each module’s top bar. The Reset button resets all of a module’s parameters to their default states (not including RTA controls). The Solo button bypasses all processing outside of the module being soloed except for master controls (polarity, input and output trim). This allows individual modules to be auditioned exclusively without hearing the effects of any of the other modules. The In button toggles the enablement of each module. If disabled, a module’s processing is bypassed and its effects will not be heard. Master Controls The Master Control section at the bottom-right corner of the plugin window contains controls for switching input polarity, adjusting input & output trim, and setting the order of routing between elements. You can change the routing order by clicking and dragging a routing item to a new position. The arrows show the direction of signal flow from top to bottom. The “ear” icon buttons to the right of the routing items indicate Router Listen points. These buttons allow you to listen to specific positions along the signal chain by automatically bypassing all modules past the selected point in the routing order. The Solo/Listen Clear button at the bottom of the Master Control section clears any active Routing Listen point as well as any modules that are soloed. It will light up to indicate whenever either of these is currently active. Processing Elements Bass Character The Bass Character is a unique EQ that follows the pitch of the note being played, allowing you to boost or cut the harmonics within each note and thus alter the actual character of the bass sound. The Bass Character has two bands: one for adjusting the Body of the note and the other for adjusting the Clarity. The corresponding band control “bubbles” on the graph are labelled “B” and “C” respectively. Equalizer The Equalizer module consists of a 5-band EQ with 2 additional filter bands, an Output Trim control, and an optional RTA display. Each band has adjustable Frequency, Gain, Shape, and Q parameters as well as the option to toggle it in or out. You can control the bands directly on the EQ Graph or with their corresponding controls below the graph. Spectral Bass Compressor The Spectral Bass Compressor is a multiband compressor designed especially for bass. It allows for applying compression selectively across 6 frequency bands focused in the lower end of the spectrum where bass notes mainly reside. On the far left of the module is an input meter displaying the level of the input signal in dB. The slider attached to it controls the overall Threshold of the compressor. Below the graph are 6 control sections containing Depth and Sensitivity controls for the corresponding band ranges which are labelled at the top of each section. The Depth parameter sets the maximum gain reduction that can be applied to the corresponding band range. The Sensitivity adjusts the level fed to the compressor’s key input for each band range. This essentially dictates how “sensitively” each band reacts to levels above the Threshold, which can help with distributing compress