Room Simulator Plenty good room for everyone Rum simulates different kinds of rooms – from acoustically treated studio booths to spaces found in an ordinary home. Think of this plug-in as if the audio source was recorded in stereo from the other side of the room, a common technique for recording acoustic instruments in order to breathe life into a dry sound source. In addition to the ten multi-recorded rooms (with different mic settings and characters that can be cross combined) there’s an advanced stereo spread and modulation unit for even more tweakability. This plug-in also comes with low cut and high cut filters, pre-delay (with tempo sync), a full set of factory presets, and a built-in ducker making it easy to tame transients on the wet signal. Anatomy 1. Make an entrance – Input gain + filter. 2. Go to your go-to room – Choose between 10 carefully sampled small rooms. 3. Make it yours – Choose mic setting + different characters of the room. 4. Move away from the walls – Simulate how far from the walls your sound source is by setting a pre-delay. 5. Need a duck? – Taming the transients in a more natural way. 6. Spread with butter – Modulation & stereo-spreader to set the final width. Features 10 different rooms with 6 variants each 3 different types of stereo spread algorithms Modulation control Ducker (compression) for the wet signal Pre-delay with tempo synchronization Low cut and high cut filters Plenty of factory presets